Rode Boompole Pro Carbon fibre

Cardioid broadcast sound quality
1400 mAh internal rechargeable lithium battery
Balanced output
+48V phantom power
High frequency boost button
High pass filter (150 Hz)
Signal to noise ratio:75 dB SPL (per IEC651)
-10 dB PAD button Acoustic Principle:Line gradient
Directional Pattern:Cardioid

Frequency Range:40 to 20k Hz (selectable HPF 150 Hz)

Sensitivity:-35±3dB(0dB=1V/Pa,at 1KHz) 1.5V 2.2kΩ

Output Impedance:200 ohm

Maximum Output:10 dBu (at 1 kHz, 1% THD into 1 kOhm)

Dynamic Range:119 dB (per IEC651)

Maximum SPL:135 dB

Signal to Noise Ratio:75 dB SPL (per IEC651)

Power:48V phantom power;

built-in lithium battery;

(battery life:150 hours)

Output Connection;

3-pin XLR

balanced output between Pin 2 (+)

Pin 3 (-) and Pin 1 (ground)

Dimensions:2.3 x 2.3 x 28.2 cm

Weight:171g (About 6 oz.)

Maximum SPL:135 dB

• Output to both DSLR camera and smartphone
• 3.5mm TRS & TRRS output cables included
• Integrated shock mount
• Plug & Use Design
• Foam windscreen included
• Rugged alluminum alloy construction for main body Model :Vmic Mini

Type:14mm Unidirectional Condenser Microphone

Frequency Range :75Hz to 20kHz

Sensitivity:-35dB +/- 3dB (0dB=1V/Pa, at 1 KHz)

Maximum input S.P.L:f=1 kHz, THD<5% (105 dB)Output Impedance :200 ohmSignal to Noise Ratio:75 dB SPLPower :Plug-in powerDimensions:62 × 117 × 19mmWeight:69g (about 2.4oz)

Stereo lavalier microphone for DSLR camera, camcorder,smartphone and recorder
Improved sensitivity and signal to noise
3.5mm audio output
5m cable length
Powered by one CR1130 battery (included)
Foam windscreen is included Type: Condenser microphone
Polar Pattern: Cardioid

Frequency Range: 50Hz to 18KHz

Sensitivity: -32±3dB (0dB=1V/Pa,at 1KHz)

Signal to Noise Ratio: >75 dB SPL

Battery Type: One LR44 battery

Cable: 5m/16.5 ft

Weight: 58g

Output: 3.5mm audio output

Two balanced XLR inputs One monitor input jack
One stereo 1/8″ (3.5 mm) mini-jack output
Left and Right control knobs allows you to adjust the signal of each channel to the optimum recording levels
M/S Switch select mono or stereo output mode
LINE / MIC/ PH Switches
PH 12V/OFF/48V Switch
Level Meter indicates the sound level in dB for each channel
The LED signal indicators flash red for overload
Gain switch selects LOW for unity gain or HIGH for +20dB boost in sound level
Headphone jack to monitor the audio from microphones or camera
AGC ON/OFF Switch —Auto Gain Control will increase the gain to maximum level, the AGC Disable function reduces the hiss when the camera is recording during quiet moments
GND1/GND2 Dual-mode grounding switch
Dual Headphone Jacks allow you to monitor the audio from the adapter at the input and output points Maximum Input Levels：

MIC 0 dB on the Level meter at -44 dBu input

LINE 0 dB on the Level meter at +10 dBu input

Output Level:Nominal MIC levels

Frequency Response:20 Hz to 20 kHz (+/- 0.5 dB)

THD:Less than 0.01% @ 1kHz, -30dBu input

S/N Ratio:85 dB @ 1 Khz, -30 dBu input

Gain:

LO gain: 0 dB

HI gain: 20 dB

Phantom Power:

Dual regulated 12 or 48 volt power supplies

Current to 14 mA (direct short)

Level meter:

-18 to +3 dB in 3 dB increments

Battery Type:One 9 volt alkaline or lithium battery

Battery Duration:

3 hours typical with alkaline battery (no phantom)

8 hours typical with lithium battery (no phantom)

Dimensions:

(L x W x H) 155 mm x 98 mm x 64 mm

Weight:21.1 oz (0.599 kg)

Directional condenser microphone
An extra 3.5mm mic input
Headphone monitor jack
Integrated shoe-mount
Low cut filter (200 Hz)
3.5mm audio output to camera
Foam windscreen included
Lightweight construction
+10dB audio level switch Microphone Type :Directional Condenser

Frequency Range:75 Hz – 18 kHz

Sensitivity:-37dB +/- 1dB

Signal to Noise Ratio:75dB SPL

Battery:1 “AAA”

Output:3.5mm TRS

Dimensions:5.5 x 2.3 x 1.6″ (14 x 5.8 x 4.1cm)

Weight:2.1 oz (30g)